Leveling and door reversal

Leveling the Dryer

Proper leveling is important for performance. The dryer must be level to help provide optimal drying performance. A perfectly level, solid floor helps minimize vibration, noise, and unwanted movement.

Before you begin - Wear long-sleeved gloves and safety glasses. - The appliance is heavy. Two or more people are required for installation. - If the dryer is being installed on the optional pedestal, use the leveling feet on the pedestal to level the appliance. The dryer’s own leveling feet should be fully retracted.

Check the level 1. Move the appliance into its final location. 2. Place a level across the top of the appliance. 3. Check that all four leveling feet rest solidly on the floor. 4. Gently push on the top corners of the appliance to make sure it does not rock from corner to corner.

Adjust the leveling feet - Use an adjustable wrench to turn the leveling feet. - Unscrew the legs to raise the appliance. - Screw in the legs to lower the appliance. - Adjust only as much as needed to make the dryer level from side to side and front to back. - Make sure all four leveling feet remain in firm contact with the floor.

Important leveling note Do not extend the leveling feet more than necessary. Extending them too far may cause the appliance to vibrate.

Reversing the Door

These instructions change the door swing from a right-side hinge to a left-side hinge. If the door has already been reversed and you need to change it back, follow the steps carefully because the left/right references will be reversed.

Before you begin - Support the door with a stool or box that fits under the door, or have another person support the door’s weight. - Avoid dropping the door. - Unplug the appliance or turn off power at the main circuit breaker before starting. - Always reverse the door before stacking the appliance on top of the washer.

Tools required - Phillips screwdriver - Large flat blade screwdriver, recommended if hinge screws are tight or the Phillips screwdriver is worn - Small flat blade screwdriver, for lifting out parts

Door reversal step shown on this page 1. Open the door. 2. Remove the 2 decorative screws, 2 latch screws, and the latch from the catch side with a screwdriver. 3. Save these parts for step 4. 4. Be sure to keep supporting the weight of the door before removing the hinge screws.

Only this first door-reversal step is shown on this page. Continue with the remaining instructions from the manual if you are completing the full door reversal.