Connect the Water Inlet Hoses

Connect the Water Inlet Hoses

Follow these steps to connect the hot and cold water supply hoses correctly and check that they are clean and leak-free.

1) Connect the hoses to the faucets - Connect the water inlet hoses to the hot and cold water faucets by hand first. - After hand-tightening, tighten each connection another 2/3 turn with pliers. - Connect the blue hose to the cold water faucet. - Connect the red hose to the hot water faucet.

2) Flush the hoses before final use - After the hoses are connected, turn on the water faucets. - Let water run through the hoses to flush out any foreign substances such as dirt, sand, or sawdust. - Drain the water into a bucket. - Check the water temperature while draining to confirm that the hoses are connected to the correct faucets.

This step helps protect the washer. Foreign substances can damage the washer inlets and may cause leakage.

3) Attach the hoses to the back of the washer - Attach the hot water inlet hose to the hot water inlet on the back of the washer. - Attach the cold water inlet hose to the cold water inlet on the back of the washer. - Tighten the fittings securely.

4) Check for leaks - Turn on both faucets all the way. - Check both ends of both hoses for leaks.

Helpful reminders from this section - Make sure the blue hose is on the cold water faucet and the red hose is on the hot water faucet. - Be sure the connections are tightened securely. - Flushing the lines before use helps remove debris and confirm the water lines are connected properly.

FAQ

Q: Which hose goes to which faucet? A: The blue hose connects to the cold water faucet, and the red hose connects to the hot water faucet.

Q: Why should I flush the water hoses before using the washer? A: Flushing removes foreign substances like dirt, sand, or sawdust. The manual says these can damage the washer inlets and cause leakage.

Q: How do I know the hoses are connected correctly? A: After connecting the hoses, let water drain into a bucket and check the water temperature. This helps confirm that the hot and cold hoses are attached to the correct faucets.

Q: How tight should the faucet connections be? A: Tighten the hoses to the faucets by hand first, then use pliers to tighten them another 2/3 turn.

Q: Should I check for leaks after installation? A: Yes. Turn on both faucets fully and check both ends of the hoses for leaks.